CNC Laser Cutter

Jinan Itech Machinery
CNC & Laser Knowledge
CNC & Laser Knowledge

Plasma problems and solving

2015-03-23 16:36:55   Edit by:Joanna    Views:
Motor is not running check system wiring loose or falls off to reconnectCheck whether there is any alarm display...
Motor is not running check system wiring loose or falls off to reconnect
Check whether there is any alarm display on the drive, set correct change drive Settings
Check system setup starting speed is zero or is too big, speed regulation time is too short, electronic gear, or whether the pulse equivalent to zero is not appropriate.Before modification Suggestions to the original parameters for recording
If it is single shaft failure or have the same model can be used to replace ruled out for parts and find out the problem to replace damaged parts
Plasma common problem analysis and solution
Motor is not running check system wiring loose or falls off to reconnect
Check whether there is any alarm display on the drive, set correct change drive Settings
Check system setup starting speed is zero or is too big, speed regulation time is too short, electronic gear, or whether the pulse equivalent to zero is not appropriate.Before modification Suggestions to the original parameters for recording
If it is single shaft failure or have the same model can be used to replace ruled out for parts and find out the problem to replace damaged parts
Plasma common problem analysis and solution

Mail to Joanna

Tel:0531-82367851

Fax:0531-82367598

Mob:18660193970

Joanna service for you